info@dis-floors.com

+45 40 26 1777

industrial floor coating dispox® - R

For heavily used surfaces

dispox® - R

The floor coating for heavily used surfaces with sufficient slip resistance, from R 11 to R 13 possible.

Area of application

  • Production facilities,
  • Turning shop,
  • milling shop,
  • grinding shop,
  • toolmaking,
  • Companies with oil spillages,
  • Engine and transmission manufacturing,
  • Wet areas,
  • Ramps,
  • Slopes,
  • Loading areas,

Characteristics

  • Three-layer epoxy resin coating with robust, non-slip surface,
  • Recommended for heavily loaded surfaces,
  • extreme early strength, approx. 70% of the characteristics after 12-18 hours at 20°C
  • High installation performance
  • Time-delayed installation possible
  • Fully coloured, homogeneous surface
  • Improved cleaning ability
  • Significantly improved cleanability when using a special cleaning agent
  • Liquid-tight on the surface
  • Many standard colours
  • Layer thickness at least 3 mm in general.

Standard version

  • 3 mm thick,
  • Structured surface,
  • Slip class R11 – R12,

Load capacity

  • up to 80 N/mm²,
  • shore D 82

Surface

  • rough,
  • grippy,
  • Slip-resistant R11 – R12

Electrical discharge capacity

  • non-conductive, > 109 Ohm
 

Flatness

  • Follow the course of the subfloor,
  • According to DIN 18 202, table 3, line 3

Substrate

  • Concrete,
  • Screed,
  • Residual moisture < 4% measured according to CM,
  • Adhesive tensile strength> 1.5 N/mm² 

Joint

  • Jointless in the surface,
  • Building joints must be accepted.