Industrial floor disfalt

For medium and high, predominantly rolling loads.

disfalt

The cold bitumen-bonded industrial floor for medium and high, predominantly rolling loads.

Area of application

Haulage and warehousing companies,
Distribution centres,
Fruit handling and ripening chambers,
Freight sheds of the railway,
Packaging companies,
Multi-storey and underground car parks

Standard version

1,0 up to 2,0 cm disfalt – industrial floor
(cold bituminous emulsion screed)

Surface

Closed,
non-slip,
asphalt grey/brown

Electrical discharge capacity

Based on DIN 51 953 between 10⁴and 10⁷ohms and therefore suitable for potentially explosive areas in Zone 0, Zone 1 and 10 in accordance with the Workplace Ordinance ArbStättV (maximum permissible value: 10⁸ohms)

Flatness

Following the level of the existing concrete substrate,
If necessary, installation in accordance with DIN 18 202, Table 3, is possible by special agreement

Surface strength

d i s f a l t – Penetration depth
Tested in accordance with DIN 1996 < 0.8 mm

Joint

Jointless in the surface,
Press joints at the day joints
Edge joints between base slab and rising components

Installation conditions

For the base slab:
Concrete, minimum quality C 20/25 (B 25) or d i s p a c – base slab, surface firm, rough, open-pored, free of sludge, separating films and loose components

For the covering:
Roof and exterior walls tight and closed, draught-free,
+ 5 °C minimum temperature

info@dis-floors.com

+45 40 26 1777