Industrial floor displan

The industrial floor solution for medium and high loads.

displan

The plastic-cement-bonded industrial floor for medium and heavy-duty use.

Area of application

Production facilities,
Warehouses,
Workshops,
Transshipment companies,
High-bay warehouses,
printing works,
DIY stores

Standard version

1,5 up to 2,5cm displan – industrial floor

Load capacity

Walkable after 3 days,
Fully loadable after 7 days (at normal climate 20°C / 65 % relative humidity)
High resistance to water, oils and many chemicals

Surface

Closed,
non-slip,
natural grey,
the surface structure is subject to regional, technical and physical building influences

Electrical discharge capacity

Based on DIN 51 953 between 10⁴and 10⁷ohms and therefore suitable for potentially explosive areas in Zone 0, Zone 1 and 10 in accordance with the Workplace Ordinance ArbStättV (maximum permissible value: 10⁸ohms)

Flatness

Following the level of the existing concrete substrate,
If necessary, installation in accordance with DIN 18 202, table 3, line 3 or 4 is possible by special agreement

Prism strength

displan – industrial floor

Compressive strength > 50 N/sqmm
Bending tensile strength > 10 N/sqmm

Joint

Jointless in the surface,
Press joints at the day joints
Building joints must be formed with suitable joint profiles

Installation conditions

For the base slab:
In-situ concrete, minimum quality C 20/25 (B 25), alternatively dispac – base slab, surface firm, rough, open-pored, free of sludge, separating films and loose components

For the covering:
Roof and exterior walls tight and closed, draught-free,
+ 5 °C minimum temperature

info@dis-floors.com

+45 40 26 1777