Industrial floor diston

For light to medium loads and as a substrate for coatings.

diston

The cement-bound, plastic-modified industrial flooring for light to medium loads and for receiving coatings.

Area of application

Garages and multi-storey car parks,
as a substrate for coatings,
as a height levelling and equalising layer,

Standard version

1,5 up to 2,5cm diston – industrial floor

Surface

Closed,
non-slip,
natural grey,
the surface structure is subject to regional, technical and physical building influences
Oil and water resistant

Electrical discharge capacity

Based on DIN 51 953 between 10⁴and 10⁷ohms and therefore suitable for potentially explosive areas in Zone 0, Zone 1 and 10 in accordance with the Workplace Ordinance ArbStättV (maximum permissible value: 10⁸ohms)

Flatness

Following the level of the existing concrete substrate,
If necessary, installation in accordance with DIN 18 202, table 3, line 3 or 4 is possible by special agreement

Prism strength

diston – industrial floor

Compressive strength > 50 N/sqmm
Bending tensile strength > 6 N/sqmm

Joint

Jointless in the surface,
Press joints at the day joints
Building joints must be formed with suitable joint profiles

Installation conditions

For the base slab:
Concrete, minimum quality C20/25 (B 25) or dispac – base slab, surface firm, rough, open-pored, free of sludge, separating films and loose components

For the covering:
Roof and exterior walls tight and closed, draught-free,
+ 5 °C minimum temperature

info@dis-floors.com

+45 40 26 1777